Use the applet below to construct a dilation by the given scale factor by following these directions:[br][list=1][*]Use the line tool to construct a line that passes through point A (the [b]center of dilation[/b]) and point B (a pre-image point)[/*][*]Use the segment tool to trace a segment from point A to point B (This is the equivalent of opening a compass up to that width)[/*][*]Use the compass tool to find an image point that is -1.5 times as far from the center of dilation as the pre-image. Use the point tool to mark that point on the applet. (Hint: a negative dilation is the same as a positive dilation but in the opposite direction from the center of dilation).[/*][*]Repeat this process for each of the other two pre-image points.[/*][*]Use the polygon tool to trace the final image.[/*][/list]